CLI Guide

Table 334. Enumerating RAID Controllers (continued)
Mandatory Options
and Arguments
Optional Parameters Valid Parameters
Arguments
Description
T10 Protection Info Capable: Yes
Encryption Capable: Yes
Encryption Key Present: Yes
RAIDCFG Command successful!
Creating Virtual Disks
The following table lists the RAIDCFG options, parameters, and predefined arguments for creating virtual disks.
NOTE: If you create a virtual disk on Windows PE, reboot the system.
Table 335. Creating Virtual Disks
Mandatory Options
and Arguments
Optional Parameters Valid Parameters
Arguments
Description
-ctrl -ac=cvd
-c=id -ad=
ch:targ,ch:targ,
... [or
ch:targ:encl,...]
or
controller
action=
createvdisk
controllerid=
id adisk=
channel:target:
lun,...
channel:target:
lun,...
[or
channel:target:
enclosure,...]
NA NA
Creates a virtual disk comprising the properties
supplied. This option combination is mandatory.
NOTE: Create a bootable virtual disk only
from the disk drives of slot 0-3 of the system.
For SCSI controllers, the value of LUN should
always be 0.
For SAS controllers, the value of enclosure can be
non-zero, in which case you must specify values
for channel, target, and enclosure.
Example:
A:>raidcfg -ctrl -ac=cvd
-c=2
-ad=1:4,1:8 -r=1 -ssz=32
-cp=d -rp=nra
-wp=wt -fd=1:1
RAIDCFG Command successful!
-cp or
cachepolicy
d or e
Valid arguments for disk cache policy are:
● d — Disable
● e — Enable
The -cp option is optional and can be added
to the command line in any order after the
mandatory option combination.
-fd or
failoverdrive
ch:targ, ch:targ, ...
or ch:targ:lun,...
or ch:targ:enc
channel:target, or
channel:target:l un,
or channel:target:
enclosure
Sets the failover drive for the virtual disk. The
-fd option is optional and can be added to the
command line in any order after the mandatory
option combination.
NOTE: From DTK 2.4 onwards, the -fd
option creates dedicated hot spares instead
of global hot spares. For information about
setting global hot spares, see Assigning,
Unassigning, And Listing Global Hot Spares.
For SCSI controllers, the value of LUN should
always be 0.
182 RAIDCFG