CLI Guide

remflashmedia
Table 291. remflashmedia
Valid Arguments read-only
Description
Displays the redundancy status of internal dual SD module. The status can be:
● Full — Secure digital card (SD) 1 and 2 are functioning properly.
● Lost — Either any of the secure digital cards or both are not functioning
properly.
The option also displays the status of the individual SD cards as follows:
● Active — The card is used for secure digital reads.
● Standby — The card is receiving a copy of all secure digital reads.
● Failed — An error is reported during a secure digital read or write.
● Absent — No secure digital media is detected.
●
Offline — At boot, card identification signature is different from the non-volatile
storage value or card is the destination of a copying operation that is in progress.
● Write Protected — The card is write-protected.
Example:
A:>syscfg --remflashmedia
Internal Dual SD ModuleRedundancy=Lost
SD1 status=Absent
SD1 status=Active
Applicable Systems
All systems prior to PowerEdge 12G systems
serial1
Table 292. serial1
Valid Arguments disable, com1, com3, com1_bmc, bmcserial, bmclan, rac
Description
Configures or reports the first serial port communication port. This option can be
replicated.
● bmcserial — maps serial port 1 to BMC Serial.
● bmclan — routes the serial traffic destined for serial1 out to NIC1.
● com1_bmc — maps serial port 1 to COM port 1 BMC.
● rac — maps serial port 1 to the RAC device.
Example:
A:>syscfg --serial1=rac
serial1=rac
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
SYSCFG 141