Deployment Guide

Error Code Message
109 The device name or index must be present in the boot order.
110 The output file could not be opened. Please make sure the path exists
and the media is not write protected.
111 Could not write to output file, disk may be full.
112 The current password must be supplied with a new password using --
oldsyspwd.
113 The current password must be supplied with a new password using --
oldsetuppwd.
114 The current password can only be supplied when setting a new password.
115 Actions are not allowed for this filter. Only alerts are allowed.
116 There was an error getting the option.
117 The option is not available or cannot be configured through software.
118 There was an error setting the option.
119 The -n (--namefile) option can only be used with - -pci.
120 The password may only contain alphanumeric characters.
121 The BIOS passwords have been disabled via jumper.
122 The password length must be between 1 and 32.
123 This password is locked and can only be unlocked by the admin user.
124 There was an error setting the password.
125 The LCD string length must be between 1 and %s.
126 The LCD string may only contain alphanumeric characters.
127 There was an error setting the LCD string.
128 The second channel can only be set if the RAID controller is set to
RAID.
129 The set operation requires sub commands.
130 The service tag for this system is not available.
131 The system ID value is not available.
132 The system information string is not available.
133 A system error has occurred.
134 Usage error.
135 The uuid information is not present on this system
136 Version cannot be accompanied with any other option.
137 The self-identify blinker timer should be set to 0..255 second(s).
138 Encrypt key is too long.
139 Encrypt key is invalid, accepted characters are 0 to 9 or A to F.
194