Deployment Guide

Table 71. AssetTag/asset* (continued)
NOTE: The Asset Tag is a string assigned to a system, usually by an
administrator, for security or tracking purposes. The Asset Tag can be up to
10 characters long and can contain only printable US-ASCII characters. For more
information on delimiters, see Command Line Option Delimiters.
Example:
A:>syscfg --asset=<ASSETTAG>
asset=ASSETTAG
Applicable Systems All PowerEdge systems except Blade systems
ErrPrompt/f1f2promptonerror
Table 72. ErrPrompt/f1f2promptonerror
Valid Arguments
● On systems prior to 12G: enable, disable
● On 12G and later systems: Enabled, Disabled
Description
Enables or disables the BIOS to prompt F1 or F2 error codes.
Example:
A:>syscfg --f1f2promptonerror=enable
f1f2promptonerror=enable
Applicable Systems PowerEdge 10G and later systems
InSystemCharacterization
Table 73. InSystemCharacterization
Valid Arguments
● On systems prior to 12G: NA
● On 12G and later systems: FastBoot, OptimizedBoot, Disabled
Description
In-System Characterization (ISC) runs during power-on self-test (POST) on
detecting relevant changes in the system configuration to optimize power and
performance. ISC takes about 20 seconds to run, and a system restart is required
to apply the system configuration changes. The FastBoot option runs ISC
and continues without applying ISC results until the next system restart. The
OptimizedBoot option runs ISC and forces an immediate system restart to apply
the results. If set to Disabled, ISC does not run.
Example:
A:>syscfg --InSystemCharacterization=FastBoot
InSystemCharacterization=FastBoot
Table 73. InSystemCharacterization
Applicable Systems PowerEdge 12G and later systems
SYSCFG 55