Deployment Guide

Table 293. pefcffgparams (continued)
Option Sub-option Valid
Arguments
Description Applicable Systems
The length of the hostname string
must be 62 characters or less for
PowerEdge 9G systems and later.
--filteralert enable,
disable
Enables or disables alerts for the
filter specified using the filter sub-
option. This sub-option is dependent
on the filter sub-option. This sub-
option can be replicated.
--alertpolnum 1, 2, 3, 4
Specifies the alert policy entry
number. This sub-option can be
replicated.
--
alertpolstatus
enable,
disable
Enables or disables the alert policy
specified using the alertpolnum
sub-option. This sub-option can
be replicated. This sub-option is
dependent on the alertpolnum
sub-option.
Example: (to set the PEF
configuration parameters):
Example 1 (To configure the PEF so
that the system is powered down in
response to a fan failure event):
A:>syscfg pefcfgparams
--filter= fanfail--
filteraction=powerdown
pefcfgparams
filter=fanfail
filteraction=powerdown
Example 2 (To configure the PEF so
that a PEF alert is not sent to the
destination IP address in response to
a chassis intrusion event):
A:>syscfg pefcfgparams
--filter= intrusion--
filteralert=disable
pefcfgparams
filter= intrusion
filteralert=disable
powerbutton
Table 294. powerbutton
Option Sub-option Valid Arguments Description
--powerbutton
NA
enable, disable
Enables or disables the power button. This option
can be replicated.
140 SYSCFG