Deployment Guide

Table 222. SYSCFG equivalent RACADM commands (continued)
Group SYSCFG Commands Equivalent RACADM Commands
--minpowercap System.Power.Cap.MinThreshold
--capenable System.Power.Cap.Enable
SYSCFG Options On PowerEdge Systems Prior To PowerEdge 12G
Systems
The following are the valid options and arguments supported on PowerEdge systems earlier than PowerEdge 12G systems.
assignintr
Table 223. assignintr
Valid Arguments standard, distributed
Description Controls the interrupt assignment of PCI devices in the system. This option is set to
standard by default, causing standard interrupt routing that uses interrupt A, B, C,
and D for all PCIe devices. When set to distributed, the interrupt routing is swizzled
at the MCH root ports to minimize sharing of interrupts across all PCIe (and PCI-X in
the Programmable Interrupt Controller (PIC) mode) devices.
Example:
A:>syscfg --assignintr=standard
assignintr=standard
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
bezelir
Table 224. bezelir
Valid Arguments enable, disable
Description Enables or disables the ESM to monitor and log front bezel intrusion conditions.
Example:
A:>syscfg --bezelir=enable
bezelir=enable
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems
cmosdefaults
Table 225. cmosdefaults
Valid Arguments enable, disable
108 SYSCFG