Deployment Guide

Features that have been removed from the MS-DOS version include:
• The --name and --wait options in the create command
• The --runlocation and the --scratchlocation options
• The --getpercentcomplete environment variables
Q: What is the minimum virtual disk size that I can create?
A: For PERC 5 controllers:
• RAID 0: 100 MB
• RAID 1: 100 MB
• RAID 5: 100 MB
For PERC 6 controllers:
• RAID 0: 100 MB
• RAID 1: 100 MB
• RAID 5: 100 MB
• RAID 6: 100 MB
• RAID 60: 100 MB
Q: Why cannot I see any controllers using RAIDCFG?
A: Ensure that the RAID controllers can be seen in the BIOS during POST. If the BIOS does not detect the controller, then RAIDCFG does
not detect it. Also ensure that the controller is set to RAID mode and not any other mode in the controller BIOS.
Q: What is span length?
A: Span length enables you to select the number of array disks in a span for the nested RAID levels (RAID-10, RAID-50, and RAID-60). The
default (minimum permissible) span length value is 2 for RAID-10, 3 for RAID-50, and 4 for RAID-60.
Q: PARTCFG cannot enumerate the virtual disks created by RAIDCFG. What must be done?
A: A reboot is required for PARTCFG to enumerate virtual disks after creating a virtual disk using the RAIDCFG command.
SYSCFG questions
Q: Can I use the SYSCFG utility to configure Point-to-Point Protocol (PPP) over the serial port to access my RAC?
A: No. The Baseboard Management Controller (BMC) firmware does not support PPP configurations for the serial port.
Q: The SYSCFG utility --lancfgparams option has suboptions that configure the IP address, Gateway, and Subnet Mask for
the system BMC. There is also a MAC address. Are these the same as the operating system network parameter of the
managed system?
A: No. The Baseboard Management Controller (BMC) has its own IP address, Gateway, Subnet Mask, and MAC address values.
Q: What is the minimum configuration needed to support BMC Platform Event Filtering?
A: You must enable LAN-channel access pefalerting and ensure that you set the BMC IP address and Gateway values for alerting.
Q: I installed the factory defaults for the BMC of my system. Then, I enabled BMC user ID 3. What is the username for this
user ID?
A: The default username for user IDs 3 to 10 is NULL.
Q: Can I use this NULL username to remotely log in to a BMC of a system?
A: No. Remote login using a NULL username is not allowed. It is recommended that you always provide a non-null, valid username for the
user ID when you enable a BMC user ID.
Q: Are duplicate usernames allowed in the BMC?
A: No. If you enter a username value that already exists, the SYSCFG utility returns an error code of 89, which means This username
is already in use. Enter a unique username.
Q: In --solcfgparams, when I set the Serial Over LAN (SOL) character send threshold using solcharsendthreshold to be 225,
I get a Hardware subsystem error. Invalid data field in request. What are the valid values?
A: The range of valid values for --solcfgparams and --solcharsendthreshold are from 1 to 220.
Q: How do I enable console redirection on a modular system?
A: Set the --serialcomm option value to enableconred. For example, syscfg -serialcomm=enableconred.
64
Known issues and frequently asked questions