Deployment Guide

passwords are limited to alphanumeric characters and cannot exceed 32 characters in
length. If a current system password is set, it must be given through the oldsyspwd
option. This option is not replicated. For more information on delimiters, see Command
Line Option Delimiters .
Example 1:
A:>syscfg --syspwd=password
The password has been set. Please use a warm reboot to apply
the password to the system.
Example 2:
A:>syscfg --syspwd=password --oldsyspwd=password
The password has been set. Please use a warm reboot to apply
the password to the system
.
NOTE: You cannot disable your password using DTK. To disable your password,
you must use the system BIOS.
Applicable Systems All PowerEdge systems
SystemCpldVersion*
Table 207. SystemCpldVersion*
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: read-only
Description
Displays the current revision of the Complex Programmable Logic Device (CPLD) of
the system.
Example:
A:>syscfg --SystemCpldVersion
Applicable Systems PowerEdge 12G and later systems
TcmActivation/tcmactivation
Table 208. TcmActivation/tcmactivation
Valid Arguments
• On systems prior to 12G: enabled, disabled, and nochange
• On 12G systems: NoChange, Activate, Deactivate
Description
Allows the user to change the operational state of the Trusted Cryptography Module
(TCM). This field is read-only when TCM Security is set to Off.
NOTE: The tcmactivation option is a sub-option of tcm.
Example:
A:>syscfg --tcmactivation=enabled
tcmactivation=enabled
Applicable Systems All systems prior to PowerEdge 13G systems.
95