Deployment Guide

IntelTxt/inteltxt

Table 201. IntelTxt/inteltxt

Valid Arguments

• On systems prior to 12G: enable, disable

• On 12G and later systems: On, Off

Description

Turns the Trusted Execution Technology on or off. To enable Intel TXT, VT must be

enabled, and the TPM must be enabled with pre-boot measurements and activated.

Example:

A:>syscfg --inteltxt=enable

inteltxt=enable

NOTE: To enable the Intel TXT option in a supported processor, make sure

that the:

• Virtualization technology in Processor setting is enabled.

• TPM module is installed and initialed as OK by BIOS.

• TPM security in System security is set to on with pre-boot measurements.

• User password is not set.

Applicable Systems All PowerEdge 11G and later systems with Intel processors.

NmiButton/nmibutton

Table 202. NmiButton/nmibutton

Valid Arguments

• On systems prior to 12G: enable, disable

• On 12G and later systems: Enabled, Disabled

Description

Enables or disables the Non-Maskable Interrupt (NMI) button on the front panel. The

NMI button can be used to alert the operating system in certain cases.

NOTE: This option configures Baseboard Management Controller (BMC) and

Remote Access Controller (RAC) settings.

Example:

A:>syscfg --nmibutton=enable

nmibutton=enable

Applicable Systems PowerEdge 11G and later systems

PasswordStatus/pwdlock

Table 203. PasswordStatus/pwdlock

Valid Arguments

• On systems prior to 12G: lock, unlock

• On 12G and later systems: Locked, Unlocked

Description

Locks the system password. To prevent the system password from being modified, set

this option to lockedand enable setup password. This field also prevents the system

password from being disabled by the user while the system boots.

Example:

A:>syscfg --pwdlock=lock

pwdlock=lock