Deployment Guide

• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the POST extended memory test.
Example:
A:>syscfg --MemTest=Enabled
MemTest=Enabled
Applicable Systems All PowerEdge systems
NodeInterleave/nodeinterleave
Table 62. NodeInterleave/nodeinterleave
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables node interleaving, if the system is configured with matching memory. If set to
disable (default), the system supports Non-Uniform Memory (NUMA) architecture
memory configurations. This field is active only if the memory configuration can
support node interleaving.
NOTE: The nodeinterleave option is same as memintleave option. For
more information, see memintleave.
Example:
A:>syscfg --nodeinterleave=enable
nodeinterleave=enable
Applicable Systems All PowerEdge systems.
redmem
Table 63. redmem
Valid Arguments off, spare, mirror, DDDC
Description
Allows selection of the required redundant memory mode, or disables redundant
memory. This option can be replicated.
Example:
A:>syscfg --redmem=off
redmem=off
Applicable Systems PowerEdge systems with Intel Xeon 7500 series processor
SerialDbgOut
Table 64. SerialDbgOut
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the RC/MRC Serial debug output.
Example:
A:>syscfg --SerialDbgOut=Enabled
SerialDbgOut=Enabled
52