Deployment Guide

Example:

A:>syscfg --DynamicCoreAllocation=Enabled

DynamicCoreAllocation=Enabled

Applicable Systems PowerEdge 12G and later systems

MemOpMode/memoperatingmode

Table 59. MemOpMode/memoperatingmode

Valid Arguments

• On systems prior to 12G: optimizer, mirror, advancedecc

• On 12G and later systems: OptimizerMode, SpareMode, MirrorMode, AdvEccMode,

SpareWithAdvEccMode

Description

Selects the memory operating mode. This feature is active only if a valid memory

configuration is detected. When OptimizerMode is enabled, the DRAM controllers

operate independently in 64-bit mode and provide optimized memory performance.

When MirrorMode is enabled, only half of the installed memory is reported as

available to the operating system. When

AdvECCMode is enabled, the two DRAM

controllers are combined in 128-bit mode to provide optimized reliability. Memory that

cannot be teamed by the controllers is not reported to the operating system. When

SpareMode is enabled, the memory size reported to the operating system does not

include the spare portion.

Example:

A:>syscfg --memoperatingmode=optimizer

memoperatingmode=optimizer

Applicable Systems PowerEdge 11G and later systems

MemOpVoltage/-dimmvoltage

Table 60. MemOpVoltage/-dimmvoltage

Valid Arguments

• On systems prior to 12G: auto, 1.5

• On 12G and later systems: AutoVolt, Volt15V

Description

Sets the DIMM voltage selection. When set to AutoVolt(default value), the system

automatically sets the voltage to the optimal setting based upon the DIMM capability

and the installed DIMM population. This option also enables setting the system DIMM

voltage to a higher (1.5V) setting if the DIMMs support multiple voltages and have

been set to a lower voltage.

NOTE: Volt15V represents 1.5 Volt.

Example:

A:>syscfg --dimmvoltage=auto

dimmvoltage=auto

Applicable Systems PowerEdge 12G and later systems.

MemTest/memtest

Table 61. MemTest/memtest

Valid Arguments

• On systems prior to 12G: enable, disable