Deployment Guide

Option Sub-option Valid Arguments Description
Example:
A:>syscfg solaction
--userid=2 --action=disable
solaction userid=2
action=disable
--userid
2–16, if your system
has a DRAC 5 controller
Specifies the BMC user ID. This sub-option can be
replicated.
--action enable, disable
Enables or disables the user ID specified using the
userid sub-option. This sub-option can be
replicated and is dependent on the userid sub-
option.
solcfgparams
Table 302. solcfgparams
Option Sub-option Valid Arguments Description
solcfgparams
Configures and displays SOL configuration
parameters. This option can be replicated.
--solenable enable, disable
Enables or disables if the SOL payload type
can be activated. This option can be
replicated.
--solprivlevel user, operator,
administrator
Sets the minimum user privilege level required
to activate the SOL. This option can be
replicated.
--solcharaccuminterval 1–255
Sets the Character Accumulate Interval in 5–
ms increments (1–255). This sets the typical
amount of time that the BMC waits before
transmitting a partial SOL character data
packet. This option can be replicated.
--solcharsendthreshold 1–255
Specifies that the BMC automatically sends an
SOL character data packet containing this
number of characters in increments of 5 (1–
255) as soon as this number of characters (or
greater) has been accepted from the
baseboard serial controller into the BMC. This
option can be replicated.
--solbitrate
9600, 19200
Sets the serial channel communication bit rate
(in bps) with the BMC when SOL is activated.
This option can be replicated.
NOTE: The arguments for
solbitrate vary with various Dell
systems. If an argument valid for a
particular Dell system is entered for
another system, the Parameter out
of range error is displayed.
136