Deployment Guide

Table 199. AesNi
Example:
A:>syscfg --AesNi=Enabled
AesNi=Enabled
Applicable Systems PowerEdge 12G and later systems
IntelTxt/inteltxt
Table 200. IntelTxt/inteltxt
Valid Arguments
● On systems prior to 12G: enable, disable
● On 12G and later systems: On, Off
Description
Turns the Trusted Execution Technology on or off. To enable Intel TXT, VT must be
enabled, and the TPM must be enabled with pre-boot measurements and activated.
Example:
A:>syscfg --inteltxt=enable
inteltxt=enable
NOTE: To enable the Intel TXT option in a supported processor, make sure that
the:
● Virtualization technology in Processor setting is enabled.
● TPM module is installed and initialed as OK by BIOS.
● TPM security in System security is set to on with pre-boot measurements.
● User password is not set.
Applicable Systems All PowerEdge 11G and later systems with Intel processors.
NmiButton/nmibutton
Table 201. NmiButton/nmibutton
Valid Arguments
● On systems prior to 12G: enable, disable
● On 12G and later systems: Enabled, Disabled
Description
Enables or disables the Non-Maskable Interrupt (NMI) button on the front panel. The
NMI button can be used to alert the operating system in certain cases.
NOTE: This option configures Baseboard Management Controller (BMC) and
Remote Access Controller (RAC) settings.
Example:
A:>syscfg --nmibutton=enable
nmibutton=enable
Applicable Systems PowerEdge 11G and later systems
98 SYSCFG