Deployment Guide

Table 118. ProcConfigTdp
Description
Configures the Thermal Design Power (TDP).
Example:
A:>syscfg --ProcConfigTdp=Nominal
ProcConfigTdp=Nominal
Table 118. ProcConfigTdp
Applicable Systems On Dell’s 13th generation PowerEdge systems and later systems.
ProcX2Apic
Table 119. ProcX2Apic
Valid Arguments
● On systems prior to Dell’s 12th generation PowerEdge systems: NA
● On Dell’s 12th generation PowerEdge and later systems: Enabled, Disabled
Description
Enables or disables the x2APIC mode.
Example:
A:>syscfg --ProcX2Apic=Enabled
ProcX2Apic=Enabled
Applicable Systems Dell’s 12th generation PowerEdge and later systems
SATA Settings
You can manage the BIOS SATA settings using the options in this group.
EmbSata / embsataraid
Table 120. EmbSata / embsataraid
Valid Arguments
● On systems prior to Dell’s 12th generation PowerEdge systems: off, combined,
ata, ahci, raid, qdma
● On Dell’s 12th generation PowerEdge and later systems: Off, AtaMode,
RaidMode, AhciMode
Description
Configures an embedded SATA RAID controller. This option can be replicated.
● off /Off — disables the embedded SATA RAID controller.
● combined— sets the SATA RAID controller to combined mode.
● ata/ AtaMode— sets SATA RAID controller to ATA mode.
● ahci/ AhciMode— sets ATA RAID controller to ahci mode.
● raid/RaidMode — sets SATA RAID controller to RAID mode.
● qdma — sets the SATA RAID controller to support ATAPI devices at transfer
rates much higher than PIO. A device driver must be installed on your system to
use the QDMA mode.
Example:
A:>syscfg --embsataraid=off
embsataraid=off
72 SYSCFG