Deployment Guide

Table 300. solaction
Option Sub-option Valid Arguments Description
solaction
This option enables or disables Serial-Over- LAN
(SOL) access for a particular user. This option
can be replicated.
Example:
A:>syscfg solaction
--userid=2 --action=disable
solaction userid=2
action=disable
--userid
2–16, if your system
has a DRAC 5
controller
Specifies the BMC user ID. This sub-option can
be replicated.
--action enable, disable
Enables or disables the user ID specified using
the userid sub-option. This sub-option can be
replicated and is dependent on the userid sub-
option.
solcfgparams
Table 301. solcfgparams (continued)
Option Sub-option Valid Arguments Description
solcfgparams
Configures and displays SOL configuration
parameters. This option can be replicated.
--solenable enable, disable
Enables or disables if the SOL payload
type can be activated. This option can be
replicated.
--solprivlevel user, operator,
administrator
Sets the minimum user privilege level
required to activate the SOL. This option can
be replicated.
--solcharaccuminterval 1–255
Sets the Character Accumulate Interval in 5–
ms increments (1–255). This sets the typical
amount of time that the BMC waits before
transmitting a partial SOL character data
packet. This option can be replicated.
--solcharsendthreshold 1–255
Specifies that the BMC automatically sends
an SOL character data packet containing this
number of characters in increments of 5 (1–
255) as soon as this number of characters
(or greater) has been accepted from the
baseboard serial controller into the BMC.
This option can be replicated.
--solbitrate
9600, 19200
Sets the serial channel communication bit
rate (in bps) with the BMC when SOL is
activated. This option can be replicated.
NOTE: The arguments for solbitrate
vary with various Dell systems. If an
argument valid for a particular Dell
system is entered for another system,
144 SYSCFG