Deployment Guide

Table 246. Sub Options And Arguments For tpm Option
Option Sub-option Arguments Description
tpmactivation as nochange. However, the TPM
feature is activated/deactivated when you reboot
the system.
--tpmclear
NA Clears the contents of the TPM chip without erasing
the tpmsecurity and tpmactivation settings.
Example:
A:>syscfg tpm --
tpmactivation=enabled --tpmclear --
setuppwdoverride
--undotpmclear
NA
Cancels the result of the tpmclear setting. If you
specify this setting before specifying the tpmclear
setting, the There is currently no pending
TPM Clear request message is displayed.
Example:
A:>syscfg tpm --
tpmactivation=enabled --undotpmclear
--setuppwdoverride
--valsetuppwd
<string>
Validates the setup password for TPM authentication.
If you try to change DTK settings, you are prompted to
enter this password to access the settings. For more
information on delimiters, see Command Line Option
Delimiters.
Example:
A:>syscfg tpm --
tpmactivation=enabled --tpmclear --
valsetuppwd=<setup_password>
--
setuppwdoverride
NA
On systems that do not have a setup password
configured, if you set this option, you are not prompted
for a password to access DTK settings.
A:>syscfg tpm --
tpmactivation=enabled --tpmclear --
setuppwdoverride
SYSCFG For BMC And Remote Access Controller
Configuration
SYSCFG configures Baseboard Management Controller (BMC) and Remote Access Controller (RAC) settings.
NOTE: Some of the following options or arguments might not be available on all systems.
NOTE: For options that use text strings such as username, password, hostname, and community string, using some
characters such as <space>, <, >, | , or = on the command line can be misinterpreted by the command line parser and cause
errors.
NOTE: The following options or arguments are also applicable to DRAC 5.
118 SYSCFG