Deployment Guide

Table 215. TpmCommand
Description
Configures the Trusted Platform Module (TPM).
● None
— Commands are not sent to the TPM.
● Activate — TPM is enabled.
● Deactivate — TPM is disabled.
● Clear — All the contents of TPM are cleared.
NOTE: This field is read-only when TpmSecurityis set to Off.
CAUTION: Clearing TPM results in loss of all keys in the TPM. This could
affect booting to operating system.
Example:
A:>syscfg --TpmCommand=Activate
Applicable Systems PowerEdge 13G and later systems
SecureBoot
Table 216. SecureBoot
Valid Arguments
● On systems prior to 12G: NA
● On 12G and later systems: Enabled, Disabled
Description
Enables or disables the BootSeqRetry feature. When set to Enabled, the system
reattempts the boot sequence after a 30-second timeout, if the last boot attempt
has failed.
Example:
A:>syscfg --SecureBoot=Enabled
SecureBoot=Enabled
Applicable Systems PowerEdge 12G and later systems
SecureBootPolicy
Table 217. SecureBootPolicy
Valid Arguments
● On systems prior to 12G: NA
● On 12G and later systems: Standard, Custom
Description
Sets the process to authenticate pre-boot images. When set to Standard, the
BIOS uses the system manufacturer keys and certificates to authenticate pre-boot
images. When set to Custom, the BIOS uses user-defined keys and certificates. The
default value is Standard.
Example:
A:>syscfg --SecureBootPolicy=Standard
SecureBootPolicy=Standard
Applicable Systems PowerEdge 12G and later systems
104 SYSCFG