CLI Guide

• On 13G and later systems: Nominal, Level1, Level2
Description
Configures the Thermal Design Power (TDP).
Example:
A:>syscfg --ProcConfigTdp=Nominal
ProcConfigTdp=Nominal
--ProcX2Apic
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the x2APIC mode.
Example:
A:>syscfg --ProcX2Apic=Enabled
ProcX2Apic=Enabled
Applicable Systems PowerEdge 12G and later systems
SATA Settings
You can manage the BIOS SATA settings using the options in this group.
--EmbSata/--embsataraid
Valid Arguments
• On systems prior to 12G: off, combined, ata, ahci, raid, qdma
• On 12G and later systems: Off, AtaMode, RaidMode, AhciMode
Description
Configures an embedded SATA RAID controller. This option can be
replicated.
• off /Off — disables the embedded SATA RAID controller.
• combined— sets the SATA RAID controller to combined mode.
• ata/ AtaMode— sets SATA RAID controller to ATA mode.
• ahci/ AhciMode— sets ATA RAID controller to ahci mode.
• raid/RaidMode — sets SATA RAID controller to RAID mode.
• qdma — sets the SATA RAID controller to support ATAPI devices
at transfer rates much higher than PIO. A device driver must be
installed on your system to use the QDMA mode.
Example:
A:>syscfg --embsataraid=off
embsataraid=off
Applicable Systems
All PowerEdge systems
--eSataPort1
Valid Arguments
• On systems prior to 12G: NA
77