CLI Guide

-- InSystemCharacterization
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: FastBoot, OptimizedBoot, Disabled
Description
In-System Characterization (ISC) runs during power-on self-test
(POST) on detecting relevant changes in the system configuration to
optimize power and performance. ISC takes about 20 seconds to
run, and a system restart is required to apply the system
configuration changes. The FastBoot option runs ISC and continues
without applying ISC results until the next sytem restart . The
OptimizedBoot option runs ISC and forces an immediate system
restart to apply the results. If set to
Disabled, ISC does not run.
Example:
A:>syscfg --InSystemCharacterization=FastBoot
InSystemCharacterization=FastBoot
--NumLock/--numlock
Valid Arguments
• On systems prior to 12G: on, off
• On 12G and later systems: On, Off
Description
Turns the keyboard number lock on or off. This option is not
replicated.
Example:
A:>syscfg --numlock=on
numlock=on
Applicable Systems All PowerEdge systems.
--ForceInt10
Valid Arguments
• On systems prior to 13G: NA
• On 13G and later systems: Enabled, Disabled
Description
Determines whether the system BIOS loads the legacy video (INT
10h) option ROM from the video controller or not. Set to Enabled if
the operating system does not support UEFI video output standards.
NOTE: This field is supported only in UEFI boot mode. This field
cannot be set to Enabled if UEFI SecureBoot is enabled.
Example:
A:>syscfg --ForceInt10=Enabled
Applicable Systems PowerEdge 13G and later systems
63