CLI Guide

Error Code Message
225 SAS 5/IR, SAS 6/IR, H200 and SW RAID requires atleast two
physical disks to create RAID 0 or RAID 1.
226 No Foreign configuration present in the controller.
227 The virtual disk cannot be created on the physical disks you
selected. Possible reasons include:unsupported mix of SAS and
SATA protocol type disks, unsupported mix of SSD and HDD media
disks.
228 Unsupported array disks selected for VD creation.
229 Setting stripe size is not supported in this controller.
230 Invalid VirtualDisk(VD) name specified. VD name can have
alphanumeric characters [A-Z,a-z,0-9,_,-] only. Also, VD name
size must be less than or equal to 15 characters
231 Error occurred while setting virtual disk as boot disk.
232 Error occurred while setting name for virtual disk.
233 Couldn't get boot virtual disk.
234 PCIe Link Speed could not be set for the RAID controller.
Please check if the controller has the capability to set/
change its PCIe link speed.
235 PCIe Link Speed can be set to either 2 or 3 i.e. PCIe
Generation 2.0 or 3.0.
236 PCIe Link Speed could not be retrieved for this RAID
controller.Please check if the controller has the PCIe link
speed capability.
237 Please reset the controller before doing any further
operation.
238 Boot Mode can be set to 0 (BIOS stop on error), 1 (BIOS
continue on error), 2 (Headless continue on error)
239 Boot Mode could not be set for the RAID controller.
240 Enable Auto Import can be set to 0 (No) or 1 (Yes).
241 Cannot discard the preserved cache because a foreign
configuration is present on the controller. Use '-
ignoreconfig' or '-igncfg' to discard the cache.
1000 Enable Auto Import property could not be set for the RAID
controller.
1001 Invalid array disk list.
1002 Source or destination disk is in invalid state. Make sure that
the source disk is in online state, destination disk is in
232