CLI Guide

TpmInfo
Table 212. TpmInfo
Valid Arguments
● On systems prior to YX3X: NA
● On YX3X and later systems: read-only
Description
Displays the TPM type and firmware version.
Example:
A:>syscfg --TpmInfo
TpmCommand
Table 213. TpmCommand
Valid Arguments
● On systems prior to YX3X: NA
● On YX3X and later systems: None, Activate, Deactivate, Clear
Description
Configures the Trusted Platform Module (TPM).
● None
— Commands are not sent to the TPM.
● Activate — TPM is enabled.
● Deactivate — TPM is disabled.
● Clear — All the contents of TPM are cleared.
NOTE: This field is read-only when TpmSecurityis set to Off.
CAUTION: Clearing TPM results in loss of all keys in the TPM. This could
affect booting to operating system.
Example:
A:>syscfg --TpmCommand=Activate
SecureBoot
Table 214. SecureBoot
Valid Arguments
● On systems prior to YX2X: NA
● On YX2X and later systems: Enabled.
Description
Enables the BootSeqRetry feature. When set to Enabled, the system re-attempts
the boot sequence after a 30-second timeout, if the last boot attempt has failed.
Example:
A:>syscfg --SecureBoot=Enabled
SecureBoot=Enabled
SYSCFG 97