CLI Guide

Table 60. MemTest or memtest (continued)
Example:
A:>syscfg --MemTest=Enabled
MemTest=Enabled
NodeInterleave or nodeinterleave
Table 61. NodeInterleave or nodeinterleave
Valid Arguments
● On systems prior to YX2X: enable, disable
● On YX2X and later systems: Enabled, Disabled
Description
Enables node interleaving, if the system is configured with matching memory. If
set to disable (default), the system supports Non-Uniform Memory (NUMA)
architecture memory configurations. This field is active only if the memory
configuration can support node interleaving.
NOTE: The nodeinterleave option is same as memintleave option. For
more information, see memintleave.
Example:
A:>syscfg --nodeinterleave=enable
nodeinterleave=enable
redmem
Table 62. redmem
Valid Arguments off, spare, mirror, DDDC
Description
Allows selection of the required redundant memory mode, or disables redundant
memory. This option can be replicated.
Example:
A:>syscfg --redmem=off
redmem=off
SerialDbgOut
Table 63. SerialDbgOut
Valid Arguments
● On systems prior to YX2X: NA
● On YX2X and later systems: Enabled, Disabled
Description
Enables or disables the RC/MRC Serial debug output.
Example:
A:>syscfg --SerialDbgOut=Enabled
SerialDbgOut=Enabled
50 SYSCFG