CLI Guide

Table Of Contents
oldsyspwd
Table 266. oldsyspwd
Valid Arguments <string>
Description
Supplies the current system password for the BIOS. This option is only given when
setting the new system password. If this password does not match the current
system password, the new password is not applied to the system. The system
password is required when booting the system. The argument string supplied to this
option is the password. Generally, passwords are limited to alphanumeric characters
and cannot exceed 32 characters in length. This option is not replicated. For more
information on delimiters see Command Line Option Delimiters.
Example1:
A:>syscfg --syspwd=<anotherpassword> --
oldsyspwd=<password>
The password has been set.Please use a warm reboot to
apply the password to the system.
Example 2:
A:>syscfg --syspwd=<asyspassword> --
oldsyspwd=<currentpassword>
The old password entered is incorrect. The new password
will not be set. Please try again.
opticaldrivectrl
Table 267. opticaldrivectrl
Valid Arguments enable, disable
Description
Enables or disables the optical CD-ROM controller.
Example:
A:>syscfg --opticaldrivectrl=enable
opticaldrivectrl=enable
remflashmedia
Table 268. remflashmedia
Valid Arguments read-only
Description
Displays the redundancy status of internal dual SD module. The status can be:
Full Secure digital card (SD) 1 and 2 are functioning properly.
Lost Either any of the secure digital cards or both are not functioning
properly.
The option also displays the status of the individual SD cards as follows:
Active The card is used for secure digital reads.
Standby The card is receiving a copy of all secure digital reads.
Failed An error is reported during a secure digital read or write.
120 SYSCFG