Reference Guide

• On 12G and later systems: Enabled, EnabledPxe, EnablediScsi,
Disabled
Description
Turns the fourth embedded NIC on with PXE enabled, off, or on
without PXE enabled. This option is only valid for supported systems
that have four embedded NICs. If the fourth NIC is enabled without
PXE, it is not found in the boot order. If the fourth NIC is turned on
with PXE, it is placed at the end of the boot order. The onnopxe
argument is not supported on all systems. This option can be
replicated.
The onwithiscsi argument enables the embedded NIC to boot from
the iSCSI server. The embnic4 option can be replicated.
Example:
A:>syscfg --embnic4=onnopxe
embnic4=onnopxe
Applicable Systems
All PowerEdge systems
--EmbVideo/--embvideoctrl
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the BIOS support for the Embedded Video
Controller
Example:
A:>syscfg --embvideoctrl=enable
embvideoctrl=enable
Applicable Systems PowerEdge 11G and later systems
--IoatEngine/--ioat
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the I/O Acceleration Technology (I/OAT) DMA
Engine option. This option must be enabled only if the hardware and
software support I/OAT on your system. This option can be
replicated.
Example:
A:>syscfg --ioat=enabled
ioat=enabled
--IntegratedNetwork1
Valid Arguments
• On systems prior to 12G: NA
48