Deployment Guide

To install Red Hat Enterprise Linux using the lininst.sh/ lininst7.sh script:
1. On the source system, navigate to the location of the required Red Hat Enterprise Linux operating
system image.
2. Create a NFS share using the following command: vi /etc/exports.
3. Share /home/rhelshare.
NOTE: If the folder you want to share is /home, then the /etc/exports file must contain the “/
home *(rw)” line.
4. Restart the NFS service.
5. Copy the operating system image to the NFS share.
6. Copy initrd.img for Red Hat Enterprise Linux to NFS share.
7. Copy vmlinuz from Red Hat Enterprise Linux operating system image to NFS share.
8. Boot DTK on the target machine.
9. Create the virtual disk using the raidcfg command.
10. Create a directory under /tmp. For example, os_src.
11. Mount the NFS Share to /tmp/os_src.
12. Copy ks.cfg/ks-rhelx.cfg (in BIOS mode) or ks_uefi.cfg/ks_rhelx_uefi.cfg (in UEFI mode) from /opt/
dell/toolkit/template/configs
to NFS share on the source machine. Here, x indicates the version of
the operating system. In BIOS mode, rename the ks_rhelx.cfg to ks.cfg. In UEFI mode, rename the
ks_rhelx_uefi.cfg to ks.cfg.
13. Edit ks.cfg (in BIOS mode) or ks_rhelx_uefi.cfg (in UEFI mode) on the source system, where x
indicates the version of the operating system. Set the NFS IP address (where Red Hat Enterprise Linux
images are available) and the NFS share path.
14. Export the environment variables as follows:
a. Run export DT_OS_DISK=/dev/sda, the disk device on which the Dell utility partition was
created.
b. Run export DT_OS_SRC=/tmp/os_src, where vmlinuz, initrd.img, and kickstart file are
available.
c. Run export DT_HD=/dev/sda.
d. For Red Hat Enterprise Linux 7, run export DT_OS_NFS_LOC=<IP address of NFS>:/<path
to os source
>. Red Hat Enterprise Linux 7 deployment is supported only on Dell Precision
R7910 and on Dell PowerEdge 13G servers.
15. Run the partcfg.sh (at /opt/dell/toolkit/template/scripts/) script to create the Dell utility partition, OS
partition in BIOS or UEFI mode.
Ensure that the correct device is set to DT_HD and DT_OS_DISK..
16. From /opt/dell/toolkit/template/scripts, run /lininst.sh (for 5.x and 6.x) or /lininst7.sh (for 7.x) script.
The server reboots to the grub prompt. The Red Hat Enterprise Linux operating system unattended
installation proceeds.
NOTE: For more information on installing, see en.community.dell.com/techcenter/systems-
management/w/wiki/1772.dell-openmanage-deployment-toolkit.aspx.
Converting to RACADM and installing Red Hat Enterprise Linux Server
Operating System using RACADM scripts
CAUTION: Do not change the bootmode before running installation scripts using syscfg. If you
do, reboot the system and start running installation scripts.
10