Users Guide

In raccap.sh:

DT_RAC_CAPFILE=$dt_systems/$dt_platform/raccfg.ini

To edit the RAC configuration variables, locate the following lines:

In RACREP.BAT:

:: RAC section

set DT_NICCFG=10.98.8.121

set DT_RAC_CAPFILE=%DT_SYSTEMS%\%DT_PLATFORM%\raccfg.ini

In racrep.sh:

# RAC section

DT_NICCFG=10.98.8.121

set DT_RAC_CAPFILE=$dt_systems/$dt_platform/raccfg.ini

Specifying variables used to create disk partitions and install the Dell utility partition

NOTE: If the primary deployment state (DT_PARTN) is set to OFF, the partitioning deployment state

subsection is skipped.

The PARTCFG.BAT (Windows) or partcfg.sh (Linux) sample script provides the following disk partitioning

default values. These values must be confirmed in some cases, and modified in other cases, before

performing a deployment. Locate the partn label to find the following lines:

In PARTCFG.BAT:

set DT_PARTN_UP=ON

set DT_MOUNT=H

:: Default Hard Drive

set DT_HD=0

:: PARTCFG section

set DT_OS_SIZE=4000

set DT_OS_FSTYPE=FAT32

if not "%DT_PARTN_UP%"=="ON" goto ospart

:: DELLUP section

set DT_UP_SIZE=32

set DT_UP_IMAGE=%DT_SYSTEMS%\UPIMG.BIN

:: RAIDCFG section:: default size for virtual disk

set DT_VD_SIZE=10480

:: default size for virtual disk

In partcfg.sh in BIOS mode:

DT_PARTN_UP=on

# Default Hard Drive

DT_HD=/dev/sda

# deployment section

set DT_DP_SIZE=64

# DELL UP section

set DT_UP_SIZE=32

set DT_UP_IMAGE=$dt_systems/upimg.bin