Users Guide

Toolkit Components Purpose

raccap.sh

Captures RAC settings to a file.

racrep.sh

Applies (replicates) the RAC settings saved in a file to the target system.

raidcfg.sh

Configures all RAID controllers detected in a system.

suseinst.sh

Performs an unattended installation of a supported SUSE Linux Enterprise

Server operating system.

syscap.sh

Captures BIOS and BMC configuration settings and saves them to a file.

sysdrmk

Used by upinit.shto patch the boot sector.

sysrep.sh

Applies (replicates) BIOS and BMC configuration settings and configures the

target system.

tkenvset.sh

Sets the path of DTK installation and variables for the specific system being

deployed.

upinit.sh

Creates and populates the Dell utility partition.

RPMs

The following table describes all DTK RPMs at mnt/cdrom/RPMs. The syscfg and raidcfg RPMs are also

available in Dell Systems Management Tools and Documentation DVD.

Table 13. RPMs

RPMs Purpose

syscfg Configures server BIOS, BMC/DRAC settings, DTK state settings, PCI device

detection, and so on.

raidcfg Configures all supported RAID controllers.

racadm Configures RAC.

NOTE: Besides the listed RPMs, a set of dependency RPMs are also available at this location.

Documentation

The following table describes documents containing reference information for each DTK utility and

instructions for using DTK utilities and sample scripts. On systems running the Windows operating

system, documentation can be found at

\Dell\Docs. On systems running the Linux operating system,

documentation can be found at mnt/cdrom/docs.