Reference Guide

NOTE: The Asset Tag is a string assigned to a system, usually by
an administrator, for security or tracking purposes. The Asset Tag
can be up to 10 characters long and can contain only printable
US-ASCII characters. For more information on delimiters, see
Command Line Option Delimiters.
Example:
A:>syscfg --asset=<ASSETTAG>
asset=ASSETTAG
Applicable Systems All PowerEdge systems except Blade systems
--ErrPrompt/--f1f2promptonerror
Valid Arguments
• On systems prior to 12G: enable, disable
• On 12G and later systems: Enabled, Disabled
Description
Enables or disables the BIOS to prompt F1 or F2 error codes.
Example:
A:>syscfg --f1f2promptonerror=enable
f1f2promptonerror=enable
Applicable Systems PowerEdge 10G and later systems
-- InSystemCharacterization
Valid Arguments
• On systems prior to 12G: NA
• On 12G and later systems: FastBoot, OptimizedBoot, Disabled
Description
In-System Characterization (ISC) runs during power-on self-test
(POST) on detecting relevant changes in the system configuration to
optimize power and performance. ISC takes about 20 seconds to
run, and a system restart is required to apply the system
configuration changes. The FastBoot option runs ISC and continues
without applying ISC results until the next sytem restart . The
OptimizedBoot option runs ISC and forces an immediate system
restart to apply the results. If set to
Disabled, ISC does not run.
Example:
A:>syscfg --InSystemCharacterization=FastBoot
InSystemCharacterization=FastBoot
--NumLock/--numlock
Valid Arguments
• On systems prior to 12G: on, off
61