Reference Guide

--BootSeqRetry/--bootseqretry

Valid Arguments

• On systems prior to 12G: enable, disable

• On 12G and later systems: Enabled, Disabled

Description Enables or disables the boot sequence retry feature. When set to

enable, the system re-attempts to set the boot order after a 30-

second time-out if the last boot attempt has failed. This option can

be replicated.

A:>syscfg --bootseqretry=enable

bootseqretry=enable

Applicable Systems All PowerEdge systems

--HddFailover/--hddfailover

Valid Arguments

• On systems prior to 12G: off, on

• On 12G and later systems: Enabled, Disabled

Descriptionoff

Specifies the device in the Hard Disk Drive Sequence menu that has

not been attempted in the boot sequence. When set to on, all

devices are attempted in an order in which they are configured.

When set to off, only the first device in the hard disk sequence is

attempted. This option can be replicated.

Example:

A:>syscfg --hddfailover=on

hddfailover=on

Applicable Systems All systems except PowerEdge 12G systems.

--SetBootOrderFqddn

Valid Arguments

• On systems prior to 13G: NA

• On 13G and later systems: <string>

Description

Displays the list of FQDDs representing the boot list to be applied on

the next boot.

NOTE: The value of n in SetBootOrderFqddn can be 1–16.

Example:

A:>syscfg --SetBootOrderFqdd1=xxxx,yyy,zzzz

SetBootOrderFqdd1=xxxx,yyy,zzzz

Applicable Systems PowerEdge 13G and later systems

--SetLegacyHddOrderFqddn

Valid Arguments

• On systems prior to 13G: NA