Reference Guide

Error Code Message
184 The operation cannot be performed at this time. The firmware
can recondition a battery that has a Degraded or Power Low
state. The firmware will not recondition a battery that is
functioning normally or that has a Ready, Failed or Missing
state.
185 The version of the controller firmware installed on your
system does not support this operation.
186 There are no disks of the correct type available to be
assigned as a hot spare.
187 There are no disks of sufficient size available to be assigned
as a hot spare.
188 There are no disks of the correct type and sufficient size
available to be assigned as a hot spare.
189 The Create Virtual Disk task was successful but the operating
system may not be aware of the new virtual disk.
191 The import of foreign configurations is complete. Some
configurations could not be imported.
192 Enable alarm command failed. The enclosure processor is busy
or a firmware download is in progress.
193 Disable alarm command failed. The enclosure processor is busy
or a firmware download is in progress.
194 Quiet alarm command failed. The enclosure processor is busy or
a firmware download is in progress.
195 An error occurred while resetting a temperature probe.
200 No array disks found!
201 Invalid Virtual Disk ID!
202 RAID Type & Size are required to create a virtual disk. Ensure
that the RAID type and the size are correct.
203 Invalid Environment command!
204 File is not writable!
205 Setting Environment Variable Command failed!
206 Filename is not provided!
207 Invalid Strict option! Please provide a valid number between 1
and 100.
208 Span depth is not needed for this RAID type.
209 Array disk(s) cannot be part of virtual disk(s) and also be
hotspares.
226