Reference Guide

Option Sub-option Valid Arguments Description
--action enable,
disable
Enables or disables the user ID specified
using the userid sub-option. This sub-
option can be replicated and is
dependent on the userid sub-option.
solcfgparams
Option Sub-option Valid Arguments Description
solcfgparams
Configures and displays SOL
configuration parameters. This
option can be replicated.
--solenable enable,
disable
Enables or disables if the SOL
payload type can be activated. This
option can be replicated.
--solprivlevel user,
operator,
administrator
Sets the minimum user privilege
level required to activate the SOL.
This option can be replicated.
--
solcharaccuminterval
1–255
Sets the Character Accumulate
Interval in 5–ms increments (1–255).
This sets the typical amount of time
that the BMC waits before
transmitting a partial SOL character
data packet. This option can be
replicated.
--
solcharsendthreshold
1–255
Specifies that the BMC automatically
sends an SOL character data packet
containing this number of characters
in increments of 5 (1–255) as soon
as this number of characters (or
greater) has been accepted from the
baseboard serial controller into the
BMC. This option can be replicated.
--solbitrate
9600, 19200
Sets the serial channel
communication bit rate (in bps) with
the BMC when SOL is activated. This
option can be replicated.
NOTE: The arguments for
solbitrate vary with various
Dell systems. If an argument
valid for a particular Dell system
is entered for another system,
the Parameter out of
range
error is displayed.
Example 1 (to display the current
SOL configuration):
A:>syscfg solcfgparams
solcfgparams
144