Reference Guide

Option Sub-option Valid
Arguments
Description
Example 2 (to set the destination IP
address as FQDN):
A:>syscfg lcp --alertdest=1
--destipaddr=xxx.yyy.com
--alertdest 1, 2, 3, 4
Sets the destination for the LAN alert.
This sub-option can be replicated.
--vlantag enable,
disable
Enables or disables VLAN tagging.
This sub-option can be replicated.
--vlanid <string>
Sets the 12-bit VLAN ID. This sub-
option can be replicated.
--vlanpriority 0–7
Sets the VLAN priority value. This sub-
option can be replicated.
--macaddress
NA Displays the BMC MAC address. This
sub-option cannot be replicated.
--nicselection
NOTE: This option is
available only with the
appropriate installed
license.
shared,
sharedfailo
ver,
dedicated,
sharedrecei
veonall
Sets the operating mode of the NIC to
shared, sharedfailover,
dedicated, or
sharedreceiveonall. Some of
these options are not applicable on
certain systems.
NOTE:
This option is applicable on systems
prior to PowerEdge 12G systems. The
sharedreceiveonall argument is
available only on PowerEdge 11G
systems.
--nicselection
NOTE: This option is
available only with the
appropriate installed
license.
dedicated,
lom1, lom2,
lom3, lom4
Sets the operating mode of the
iDRAC7 NIC to dedicated, lom1,
lom2, lom3, or lom4. Some of these
options are not applicable on certain
systems due to underlying hardware.
NOTE: This option is applicable
on PowerEdge 11G systems.
--
nicselectionfailover
NOTE: This option is
available only with the
appropriate installed
license.
none, lom1,
lom2, lom3,
lom4, all
Sets the operating mode of the NIC
selection failover to none, lom1,
lom2, lom3, lom4, or all. Some of
these options are not applicable on
certain systems. due to underlying
hardware.
NOTE: This option is applicable
on PowerEdge 12G systems.
--fullduplex
enable,
disable
Enables or disables full duplex on the
RAC network interface.
131