Reference Guide

--formfactor
Valid Arguments read-only
Description
Displays the geometry of PowerEdge Blade systems. The option can
have the following values: halfheight (the Blade systems occupies 1
slot of the chassis), halfheight, dualwide (the Blade system occupies
2 horizontal slots of the chassis), fullheight (the Blade system
occupies 2 vertical slots of the chassis), fullheight, dualwide (the
Blade system occupies 4 slots of the chassis) and quarterheight (the
Blade systems occupies half slot of the chassis).
Example:
A:>syscfg --formfactor=fullheight, dualwide
formfactor=fullheight, dualwide
Applicable Systems
All PowerEdge blade systems prior to PowerEdge 12G systems.
--hddfailover
Valid Arguments
off, on
Descriptionoff
Specifies the device in the Hard Disk Drive Sequence menu that has
not been attempted in the boot sequence. When set to on, all
devices are attempted in an order in which they are configured.
When set to off, only the first device in the hard disk sequence is
attempted. This option can be replicated.
Example:
A:>syscfg --hddfailover=on
hddfailover=on
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--hpcmode
Valid Arguments
enable, disable
Description
Enables or disables the High Performance Computing (HPC) Mode.
When set to enable, the HPC is enabled utilizing only the high
frequency P-State settings. When set to disable (default value), all P-
States inherent to the CPU are used.
To fully enable HPC Mode, set the power management to custom,
cpu power and performance management to OsDbpm, and fan
power and performance management to maximum performance.
Example:
A:>syscfg --hpcmode=enable
hpcmode=enable
121