Reference Guide

Option Sub-option Valid
Arguments
Description
--vlantag enable,
disable
Enables or disables VLAN tagging.
This sub-option can be replicated.
--vlanid <string>
Sets the 12-bit VLAN ID. This sub-
option can be replicated.
--vlanpriority 0–7
Sets the VLAN priority value. This sub-
option can be replicated.
--macaddress
NA Displays the BMC MAC address. This
sub-option cannot be replicated.
--
nicselectionfailover
NOTE: This option is
available only with the
appropriate installed
license.
none, lom1,
lom2, lom3,
lom4, all
Sets the operating mode of the NIC
selection failover to none, lom1,
lom2, lom3, lom4, or all. Some of
these options are not applicable on
certain systems. due to underlying
hardware.
--fullduplex
enable,
disable
Enables or disables full duplex on the
RAC network interface.
--autoneg enable,
disable
Enables or disables autonegotiation.
--speed 10,100
Sets the network interface speed to
10 or 100 Mbps.
--dnsdhcp enable,
disable
Enables or disables obtaining the DNS
server IP address through DHCP.
--dnsserver1 <ipaddress>
Sets the IP address of the primary
DNS server for domain name
resolution.
--dnsserver2 <ipaddress>
Sets the IP address of the secondary
DNS server for domain name
resolution.
--dnsregisterrac enable,
disable
Enables or disables binding of the
RAC name to the IP address.
--dnsracname <string>
Sets the name of the RAC.
--domainnamefromdhcp enable,
disable
Enables or disables getting the RAC
domain name through DHCP.
--domainname <string>
Sets the domain name of the RAC.
79