Reference Guide

population. This option also enables setting the system DIMM voltage

to a higher (1.5V) setting if the DIMMs support multiple voltages and

have been set to a lower voltage.

NOTE: Volt15V represents 1.5 Volt.

Example:

A:>syscfg --MemOpVoltage=AutoVolt

--MemTest

Valid Arguments Enabled, Disabled

Description

Enables or disables the POST extended memory test.

Example:

A:>syscfg --MemTest=Enabled

--NodeInterleave

Valid Arguments

Enabled, Disabled

Description

Enables node interleaving, if the system is configured with matching

memory. If set to Disabled (default), the system supports Non-

Uniform Memory (NUMA) architecture memory configurations. This

field is active only if the memory configuration can support node

interleaving.

Example:

A:>syscfg --NodeInterleave=Enabled

--RedundantMem/--redmem

Valid Arguments

• On systems prior to 12G: off, spare, mirror, DDDC

• On 12G and later systems: Disabled, Spare Mode, Mirror Mode,

Intra-Node Mirror Mode, DIMM Spare Mode, Double DRAM ECC

Description

Allows selection of the required redundant memory mode, or

disables redundant memory. This option can be replicated.

Example:

A:>syscfg --redmem=off

redmem=off

Applicable Systems PowerEdge M910, R910, and R810 systems and 12G systems with

Intel Xeon 7500 series processor