Reference Guide

Error Code Message
234 PCIe Link Speed could not be set for the RAID controller.
Please check if the controller has the capability to set/
change its PCIe link speed.
235 PCIe Link Speed can be set to either 2 or 3 i.e. PCIe
Generation 2.0 or 3.0.
236 PCIe Link Speed could not be retrieved for this RAID
controller.Please check if the controller has the PCIe link
speed capability.
237 Please reset the controller before doing any further
operation.
238 Boot Mode can be set to 0 (BIOS stop on error), 1 (BIOS
continue on error), 2 (Headless continue on error)
239 Boot Mode could not be set for the RAID controller.
240 Enable Auto Import can be set to 0 (No) or 1 (Yes).
1000 Cannot discard the preserved cache because a foreign
configuration is present on the controller. Use '-
ignoreconfig' or '-igncfg' to discard the cache.
1001 Invalid array disk list.
1002 Source or destination disk is in invalid state. Make sure that
the source disk is in online state, destination disk is in
ready state, and the size of the destination disk is greater
than or equal to the size of the source disk.
1003 Operation not allowed. Cannot set the array disk state to
online.
1004 Operation not allowed. Cannot set the array disk state to
offline.
1005 Invalid encrypted array disk list for the instant secure erase
operation.
1006 Sector drives 512B and 4KB must not be combined while creating
a virtual disk.
1007 Hot spare sector size for the virtual disk is not matching.
1008 sectorsize parameter is not found.
1009 Warning! Cannot assign global hotspare. Input array disk can
act as a hotspare only for virtual disks with matching sector
size (4KB or 512B) and supported T10 PI capability. Use "-
force" option to discard the warning.
1010 Force option is invalid for this operation on the specified
controller.
175