Reference Guide

Example:
A:>syscfg --floppy=auto
floppy=auto
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--formfactor
Option
––formfactor
Valid Arguments read-only
Description
Displays the geometry of PowerEdge Blade systems. The option can have the
following values: halfheight (the Blade systems occupies 1 slot of the chassis),
halfheight, dualwide (the Blade system occupies 2 horizontal slots of the
chassis), fullheight (the Blade system occupies 2 vertical slots of the chassis),
fullheight, dualwide (the Blade system occupies 4 slots of the chassis).
NOTE: On 12G systems, the option will have an additional value,
quarterheight (the Blade systems occupies half slot of the chassis).
Example:
A:>syscfg --formfactor=fullheight, dualwide
formfactor=fullheight, dualwide
Applicable Systems All PowerEdge blade systems including 12G systems.
--fsbr
Option
--fsbr
Valid Arguments 115200, 57600, 19200, 9600
Description
Sets the console redirection fail safe baud rate in bps.
Example:
A:>syscfg --fsbr=9600
fsbr=9600
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
--hddfailover
Option
--hddfailover
Valid Arguments off, on
Descriptionoff
Specifies the device in the Hard Disk Drive Sequence menu that has not been
attempted in the boot sequence. When set to on, all devices are attempted in
an order in which they are configured. When set to off, only the first device in
the hard disk sequence is attempted. This option can be replicated.
Example:
A:>syscfg --hddfailover=on
hddfailover=on
Applicable Systems All PowerEdge systems prior to PowerEdge 12G systems.
37