Reference Guide

--embsdcardredundancy
Option
--embsdcardredundancy
Valid Arguments mirrormode, disable
Description
Sets the redundancy to mirrormode or disabled.
If set to mirrormode, read-write operation occurs on both the secure digital
(SD) cards. If one of the SD cards fails and is replaced, on booting, the data is
copied to that SD card.
If set to disable, read-write operation occurs only on SD card 1.
On Blade systems, disable the vflash key to configure this option.
Example:
A:>syscfg --embsdcardredundancy=mirrormode
embsdcardredundancy=mirrormode
Applicable Systems PowerEdge R810, R815, R910, and M910 systems
--extserial
Option
--extserial
Valid Arguments com1, com2, rad
Description
Sets the behavior of the external serial connector. When set to com1 , the BIOS
maps the external serial connector to COM port 1. The com1 setting is the
default.
When set to com2 , the external serial connector is routed to the COM2
interface. Terminal escape sequences can toggle the external connector
between the system (COM2) and the remote access device.
When set to rad , the external serial connector is routed to the remote access
device interface. Terminal escape sequences can toggle the external
connector between the system (COM2) and the remote access device.
This option can be replicated.
Example:
A:>syscfg --extserial=com1
extserial=com1
The --serialcomm option can be used with the external serial (--extserial)
option instead of the --conred (available on systems earlier than PowerEdge 9G
systems) option.
Applicable Systems
All PowerEdge systems prior to PowerEdge 12G systems except Blade
systems.
--embsdcard
Option
--embsdcard
Valid Arguments off, on
Description
Enables or disables the embedded SD card port.
35