Quick Reference Guide

Error Code Message
205 Invalid alert destination.
206 The set operation failed due to unspecified error.
207 Incorrect syntax for help. For more information about a
particular command, use the option '-h or --help' followed by
the command name. Example: %s -h --asset
Failures And Solutions
The following table lists the common SYSCFG failures and their solution.
Table 81. SYSCFG Failures and Solutions
Failure Messages Solutions
Generic failure. Indicates iDRAC is in bad state. Reboot iDRAC.
New value not valid. Make sure the changed value is valid.
Cannot disable this orderedList’s
entries.
BIOS does not support enabling or disabling of a particular boot order object.
System busy, try again later. Retry as iDRAC is busy with internal processing.
Unable to connect IDRAC data
manager.
Start data manager service using srvadmin_services (specific to Linux).
System Services and/or CSIOR
disabled.
Enable CSIOR from <F2> screen.
UPINIT Common Error Codes And Messages
The UPINIT utility checks your commands for correct syntax. When you enter a command, a message is displayed
stating the results of the command.
Failure Messages
The UPINIT utility failure messages provide error codes to help diagnose why some commands do not succeed. Table
below lists error codes and messages common to Linux and Microsoft Windows PE environments.
Table 82. UPINIT Common Error Codes and Messages
Error Code Message
0 Dell Utility Partition created successfully.
1 Error: Disk ID not specified.
2 Error: SIZE not specified.
3 Error: Utility Partition Image file not specified.
4 Error: DRMK Path not specified.
153