Owner's Manual

A: You can apply driver disks as follows:
1. During operating system installation, after the first reboot, attach the driver-disk.iso file to the DVD-ROM or virtual
media.
2. At the grub prompt, press <a> followed by <dd> and, then press <Enter>.
Q: Why DTK ELI (32–bit) does not successfully boot up a Dell server running in UEFI mode?
A: On a Dell server running in UEFI mode, DTK supports only 64–bit ELI.
Windows PE Questions
Q: My system gets the error Illegal or Missing File Types Specified in Section
Files.SCSI.Name during an unattended installation of a supported Windows operating system on supported Dell
systems.
A: This behavior can occur when the line in the Txtsetup.oem file under the [Files.SCSI. name ] heading is not a
supported file type. To resolve this behavior, you must remove the line in the Txtsetup.oem file. The dynamic-link library
(DLL) file can be copied to the correct location of the installation by placing it in the I386\$Oem$\$$\OEMDIR folder.
(OEMDIR is the destination folder where the file would normally be located, if installed to a running operating system.
For example, INF files are normally found in the %SystemRoot%\INF folder. The correct OEMDIR destination can be
found by searching the INF file used to install the device or driver.) For more information, see Microsoft Knowledge Base
Article 275334 available at Microsoft website.
Q: In Windows, I see a blue screen when I delete a virtual disk and create a new one without initialization and attempt to
format the disk.
A: Initialize (fast init) the drives before formatting the disk. This prevents the issue.
71