Quick Reference Guide

Example 1:
A:>syscfg --devseq
The following devices are set in the disk device
sequence:
Device 1:* hdd.emb.0 - System BIOS boot devices
Device 2:* scsiraid.slot.3 - PERC 5/E Adapter(bus
02 dev 02)
Device 3:* usbkey.slot.0 - Hard-disk-emulated USB
flash drive
Example 2:
A:>syscfg --devseq= hdd.emb.1,scsiraid.emb.1
The following devices are set in the disk device
sequence:
Device 1:* hdd.emb.0 - System BIOS boot devices
Device 2:* scsiraid.emb.1 - AIC-7899, A:00 Seagate
NOTE: The asterisk indicates that the device is enabled in the BIOS.
Applicable Systems
All PowerEdge systems prior to PowerEdge 12G systems.
--embhypervisor
Option
--embhypervisor
Valid Arguments off, on
Description
Turns on or off the embedded hypervisor port.
Example:
A:>syscfg --embhypervisor=on
embhypervisor=on
Applicable Systems All PowerEdge systems prior to PowerEdge yx2x systems
--embideraid
Option
--embideraid
Valid Arguments on, off
Description
Turns on or off the embedded IDE RAID controller. This option is only valid for
supported systems that have IDE ROMB. This option can be replicated.
Example:
A:>syscfg --embideraid=on
embideraid=on
Applicable Systems All PowerEdge systems prior to PowerEdge yx2x systems
32