Quick Reference Guide

Error Code Message
194 Quiet alarm command failed. The enclosure processor is busy or
a firmware download is in progress.
195 An error occurred while resetting a temperature probe.
200 No array disks found!
201 Invalid Virtual Disk ID!
202 RAID Type & Size are required to create a virtual disk. Ensure
that the RAID type and the size are correct.
203 Invalid Environment command!
204 File is not writable!
205 Setting Environment Variable Command failed!
206 Filename is not provided!
207 Invalid Strict option! Please provide a valid number between 1
and 100.
208 Span depth is not needed for this RAID type.
209 Array disk(s) cannot be part of virtual disk(s) and also be
hotspares.
210 Cannot have silent and logfile switch with the same command.
211 Invalid array disk(s)!
212 Invalid failover disk(s)!
213 Creation of a virtual disk on this RAID controller requires
the use of the entire disk space of the array disks. The size
or - sz parameter is not needed.
214 Invalid size given! size=max or -sz=max is not supported for
this RAID controller.
215 The value given for envname or -envn is null or too long.
216 Invalid virtual disk size!
217 The strict option provided failed! Virtual disk is not
created.
218 Unable to determine optimum size for Virtual disk. Ensure that
the array disks are of the same protocol (i.e. SAS, SATA,
SCSI). If there is a mismatch of the array disks then the
RAIDCFG will not be able to determine the optimum size. In
addition, also ensure that there is drive size available for
the specified virtual disk.
219 One or more array disks selected to create virtual disk or
hotspare doesn't have enough disk space. Please make sure that
all the array disks and failover drives selected have enough
free space.
160