Quick Reference Guide

Error Code Message
73 The sequence list must be a comma-separated numerical list of
valid unique boot device numbers (ex: 2, 1, 3).
74 The sequence list must be a comma-separated list of valid
unique device names (ex: nic.emb.1, hdd.emb.1) or a comma-
separated numerical list of valid unique boot device numbers
(ex: 2, 1, 3).
75 There was an error setting the sequence.
76 The list is not formatted correctly. See the help for more
details.
77 The size of returned buffer is larger than the size of
allocated buffer.
78 There was a problem getting the state byte.
79 The state byte is not available on this system.
80 There was a problem setting the state byte.
81 The state byte must be a value between 0 and 255 decimal.
82 The CPU information is not available.
83 The dependent option '%s' required for this subcommand is
missing in the command line.
84 Duplicate sub command '%s' has been entered.
85 The script file does contain not a valid DTK environment
script signature.
86 The format of the environment variable is incorrect.
87 The --envar option can only be used for a single option.
88 The --envar option can only be used for report operations.
89 The individual sub commands should be specified for the -s
option.
90 Getting external serial connector settings failed.
91 Setting external serial connector settings failed.
92 There was an error opening the file.
93 File ’%s’does not have write permission.
94 The file contains invalid options ’%s’.
95 The replication information does not match for this system.
96 There can only be one section in the input file.
97 Bad ini file, the section cannot be found.
98 The format of the bios image file is incorrect.
99 Report operations and set operations must be separate.
146