Quick Reference Guide

Mandatory Options
and Arguments
Optional Parameters Valid Parameters
Arguments
Description
• wc — Write-Caching sets the
controller to send a write-request
completion signal only after the data
is written to the disk.
• nwc — No-Write-Caching specifies
that the controller does not send a
write-request completion signal after
the data is written to the disk.
NOTE: The -wpoption is optional and can
be added to the command line in any
order after the mandatory option
combination.
For SCSI controllers, the value of LUN should
always be 0.
For SAS controllers, the value of enclosure
can be non-zero, in which case you must
specify values for channel, target, and
enclosure.
Enumerating Array Disks
The following table lists the RAIDCFG options, parameters, and pre-defined arguments for enumerating array disks (hard
drives).
NOTE: You can also use pdisk or -pd instead of adisk or -ad to specify an array disk.
Table 59. Enumerating Array Disks (Hard Drives)
Mandatory Options
and Arguments
Optional Parameters Valid Parameters
Arguments
Description
-ad -c=id or
adisk
controllerid=i
d
NA NA
Lists all the array disks attached to the
specified RAID controller. This option
combination is mandatory.
NOTE: The following example displays
output of a Series 7 controller.
NOTE: Software controller does not
display the NegSpeed, CapSpeed,
Certified and Supported
parameters.
Example:
A:>raidcfg -ad -c=2
Controller: PERC H700 Adapter
****** Physical Drive ******
Vendor: DELL(tm)
Model: ST9146703SS
Protocol: SAS
Media: HDD
123