Quick Reference Guide

SYSCFG 93
--MemOp
Voltage
AutoVolt, Volt15V Sets the DIMM voltage
selection. When set to
AutoVolt (default value),
the system automatically
sets the voltage to the
optimal setting based upon
the DIMM capability and
the installed DIMM
population. This option
also enables setting the
system DIMM voltage to a
higher (1.5V) setting if the
DIMMs support multiple
voltages and have been set
to a lower voltage.
NOTE: Volt15V represents
1.5Volt.
--MemTest Enabled, Disabled Enables or disables the
POST extended memory
test.
--Node
Interleave
Enabled, Disabled Enables node interleaving,
if the system is configured
with matching memory. If
set to Disabled (default),
the system supports Non-
Uniform Memory (NUMA)
architecture memory
configurations. This field is
active only if the memory
configuration can support
node interleaving.
--SerialDbgOut Enabled, Disabled Enables or disables the
RC/MRC Serial debug
output.
Table 3-6. SYSCFG Options and Arguments for BIOS Configuration on PowerEdge
yx2x
Systems
(continued)
Group Option Valid Arguments Description