Quick Reference Guide

166 RAIDCFG
• PERC S110, PERC S100, PERC 310, and PERC S300 software controllers
(Not supported on 64-bit systems)
• CERC SATA 1.5/6-Channel (CH) and CERC SATA 1.5/2S (These
controllers are supported on Linux only.)
• SAS 6iR integrated, SAS 6iR adapter
• SAS 5iR integrated, SAS 5iR adapter
RAIDCFG Dependencies
For the RAIDCFG utility to run successfully in Windows PE, the mr2kserv,
lsivil.dll (for Windows) or lsivil.so (for Linux) and sasvil.dll (for Windows)
or sasvil.dll (for Linux) must be in the same directory as RAIDCFG.
The mr2kserv is a service that is automatically started by the DTK startup
script. This service is required to configure all LSI RAID controllers in
Windows PE and provides Plug and Play support.
RAIDCFG Options and Arguments
Table 4-1 lists all of the valid options, parameters, and arguments for the
RAIDCGFG utility. For more information on valid RAIDCFG options and
their specific uses, see "RAID Configuration Utility Options and Arguments"
on page 172.
Mandatory command line options must be present in the command.
Optional command line options can be typed in any order after all mandatory
options have been typed. Many options have both a short and long format.
Short and long format options cannot be used in the same command line
instance.
Table 4-1 shows some examples of valid and invalid short and long format
command line instances. See "RAID Configuration Utility Options and
Arguments" on page 172 for an explanation of the specific order for each
option. See Table 4-16 for a list of frequently used RAID commands.
NOTE: Some of the following options or arguments might not be available on all
systems.