Owner's Manual

 DTK does not support Non RAID (Volume) mode on S100/S300 controller.
 S300 controller Cachepolicy setting is "Not Applicable". Hence VD created with different cachepolicy settings from
OROM utility will be displayed as "Not Applicable".
 USB keys should not be mounted to the /tmp directory. Inside the /tmp directory, create a new directory and
mount the USB to this.
 On Dell PERC H310 controllers, conversion of a RAID Capable Disk to Non-RAID disk and vice versa is not supported
using raidcfg.
SYSCFG Issues
 In DRAC 5, the --virtualmedia and --vflash options do not work if there is an active virtual media
session. Disconnect the virtual media using the DRAC GUI. Log into DRAC. Click Media > Virtual
Media > Disconnect.
 The syscfg --bootseq command detects CD-ROM with SAS/SATA controllers as unk.emb.1.
 On R815, syscfg power --profile option allows to set to apc, though apc is not supported on R815.
syscfg does not throw an error message.
 The option for "powerctl," "softshutdown," causes your system to reboot. If you use a customized
kernel with Advanced Configuration and Power Interface (ACPI) support, this option will work as
designed.
 Using the "solcfgparams" option may produce an error message saying "Hardware subsystem error"
when an invalid value is used. This does not indicate a problem with the hardware. Check the
option value and try again.
 The "--solbitrate" option in "solcfgparams" and the "--msgcommbitrate" option in "serialcfgparams"
accept a baud rate of 57600.
 On PowerEdge 1950, 2950 and PowerVault NX 1950 systems with internal USB, BIOS setting
configuration for internal USB Port is possible only if User Accessible/external (UA) USB ports are
set to "All Ports On." If UA USB ports are not set to "All Ports On" and you try to configure the BIOS
setting for the internal USB port using SYSCFG, the configuration will appear to be successful but
the changes will not take effect after the next reboot. If UA USB ports settings are changed from
"All Ports On" to "All Ports Off" or "Only Back Ports On," the USB port will be automatically set to
"Off" during the next reboot.
RACADM Issues
 The "racadm gettracelog" option may cause the system to hang. You may need to restart the
system.
 After generating the rac configuration file using the "racadm getconfig -f <file_name>" command,
comment out the following properties in the configuration file before you update a configuration
using the "racadm config -f <file_name>" command:
o #cfgRacTuneCtrlEConfigDisable=0
o #cfgRacTuneLocalConfigDisable=0