Owner's Manual

 Running partcfg.bat may fail when virtual media is enabled. For the hard disk, partcfg.bat uses the driver letter
"c:". When virtual media is enabled, sometimes, the virtual device gets assigned with the drive letter "c:" And,
partcfg.bat execution fails. To run partcfg.bat successfully, either disable the virtual media or use the diskpart
command to assign a free driver letter for partcfg.bat.
Windows PE Issues
 Windows PE 2.0 and 3.0 for 64-bit do not support racadm.exe for DRAC 4.
 Windows 2008 64-bit cannot be installed using DTK with Windows PE 3.0. Use Windows PE 2.0 for installing
Windows 2008 64-bit.
 When using the H200 driver provided in Windows PE 3.0 (64-bit), the diskpart command does not list the first
virtual disk created. Download the latest driver from the support site at support.dell.com.
 Windows PE 3.0 does not support PERC 4 controllers.
Global Support
For information on technical support, visit dell.com/contactus .
For information on documentation support, visit support.dell.com/manuals. On the Manuals page, click
Software ‐> Systems Management. Click on the specific product on the right‐side to access the documents.
Information in this document is subject to change without notice.
© 2012 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell™, the DELL logo, PowerEdge™, OpenManage are trademarks of Dell Inc. Microsoft®, Windows®, and
Windows Server® are registered trademarks of Microsoft Corporation in the United States and/or other countries.
Other trademarks and trade names may be used in this publication to refer to either the entities claiming the marks and names or their products. Dell
Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
2012 – 6 Rev. A00