Owner's Manual

Setting Up a Directory Structure for Deployment 47
To deploy on Windows Server 2008 operating systems:
1
Create an operating system-specific directory in the root directory of the
network share. For example,
W2K8_deploy.
2 Create two directories under the W2K8_deploy directory: sources and
< platform name > , for example, PE2950 . Copy the contents of the
operating system media to
sources .
NOTE: The platform name must be a DTK standard name. To know
the platform name, run
TKENVSET.BAT located in the
x:\Dell\32\Toolkit\Template\Scripts directory, and then run the SET
command. In the Details section, see the DT_PLATFORM name.
3 Under PE2950 , create two directories: $OEM$ and Out-of-Box Drivers .
4 Copy all the drivers to W2K8_deploy\PER720\ Out-of-Box Drivers . You
can copy each driver to a different sub-folder.
5 Copy unattend.xml from \Toolkit\Template\Configs to
W2K8_deploy\PER720 .
6 If required, modify the unattend.xml for DiskID under the tags
DiskConfiguration and ImageInstall . Default value is 0 for DiskID .
7 Make sure that DiskID specified in the unattend.xml is actually available
to install the operating system. You can run the
DiskPart utility to check
disk details.
8 Boot your system with DTK Windows PE image.
9 Run the following command to connect the target system to the shared
folder
W2K8_deploy .
X:\Dell\Toolkit\Tools net use z: \\<IP address of
the management station>\W2K8_deploy
10
From your system, run TKENVSET.BAT under
\Toolkit\Template\Scripts.
11
On your system, set the environment variable DT_DRIVE=Z: .
12 Navigate to Toolkit\Template\Scripts and run W2K8INST.BAT .