Owner's Manual

40 Downloading DTK
RPMs
Table 3-9 describes all DTK RPMs located at mnt/cdrom/RPMs.
NOTE: Besides the listed RPMs, a set of dependency RPMs are also available in
this location.
racrep.sh Applies (replicates) the RAC settings saved in a file to the target
system.
raidcfg.sh Configures all RAID controllers detected in a system.
suseinst.sh Performs an unattended installation of a supported SUSE Linux
Enterprise Server operating system.
syscap.sh Captures BIOS and BMC configuration settings and saves them
to a file.
sysdrmk Used by upinit.sh to patch the boot sector.
sysrep.sh Applies (replicates) BIOS and BMC configuration settings and
configures the target system.
tkenvset.sh Sets the path of DTK installation and variables for the specific
system being deployed.
upinit.sh Creates and populates the Dell utility partition.
Table 3-9. RPMs
RPMs Purpose
syscfg Configure server BIOS, BMC/DRAC settings, DTK state settings,
PCI device detection, and so on
raidcfg Configures all supported RAID controllers
racadm Configures RAC
Table 3-8. Sample Scripts for Linux
(continued)
Toolkit Components Purpose